Chain fence with geometry nodes

几乎把所有参数暴露出来了，破损的范围可以进入几何节点调节

随意使用

灵感来源于@Nick_Encrypt 和Curvify插件

更多细节看A站，点个赞更好

Almost all parameters are exposed, and the damaged range can be adjusted by entering the geometry node

Feel free to grab it and use it in your own projects (I’d love to see if you do)

If you like it and found it helpful, please consider leaving a review and a tip. It would be greatly appreciated :)

inspired from @Nick_Encrypt and Curvify

more details on my Artstation

Blender3.4

update v1.1:

Works fine on sloped surfaces, but due to the original design it is difficult to run the wire perpendicular to the slope.

I think it is in line with daily usage to directly point the column to the z direction. If the vertical slope must be vertical, you can use the cross product of the tangentand normal vectors, but that will cause crossing. It’s okay if the direction is the same, but there will be big problems if they don’t. In short, you can’t have both